Banner
Home > Hua Hin Information > Content

How to clean the needle detector of sewing equipment

How to clean the needle detector of sewing equipment

In useSewing equipmentWhat do you have to pay attention to? That is cleaning. If daily maintenance of the sewing machine can be done, it can prevent dust, thread ends from accumulating, and failures will not occur, so that the machine can be used in a good condition. Therefore, it is usually necessary to clean up the sewing equipment after a period of use. Especially for the needle detector, it is necessary to clean the conveyor belt and other parts that are easily contaminated during normal use.

针车缝纫设备.png

The specific cleaning methods and precautions of the needle detector for sewing equipment are as follows:

One is to clean the surface of the conveyor belt. First, find a clean towel, damp it and wring it dry, until no water can come out. Secondly, pay attention to adjusting the sensitivity of the needle detector of the sewing equipment to a lower level before cleaning. If the level of the needle detector has 1 to 10 levels, please adjust the needle detector to a lower level 1 mode to avoid high sensitivity affecting the next cleaning work. Thirdly, straighten the towel, press it properly on the surface of the conveyor belt, start the sewing equipment of the sewing machine, and run the machine for more than 5 revolutions. The purpose is to clean the contaminants on the surface of the conveyor belt. This method can be used flexibly. Then wash the towel and wring dry, repeat the cleaning step until there is no obvious contamination on the surface of the conveyor belt.

The second is to clean the back of the conveyor belt. First remove the metal shells on the left and right sides of the conveyor belt of the needle detector of the sewing equipment, then wash and wring out the towel, pass the towel through the bottom of the conveyor belt, straighten the towel, grab both ends of the towel, and run it for several weeks. Since the bottom of the conveyor belt is dirty, it needs to be wiped repeatedly. Therefore, every time the sewing machine is operated for several weeks, the towel should be taken out and cleaned, and then the above cleaning steps should be repeated again.

After the above cleaning steps are completed, if the probe light continues to flash after the needle detector of the sewing equipment is turned on and the clothes cannot pass smoothly, the above cleaning steps should be repeated again. At the same time, it is worth noting that when the needle detector of sewing equipment is cleaned and tested, special attention should be paid to avoid the interference of surrounding environmental factors, such as people walking, large machines too close and other factors.

针车缝纫机.png